HS: More Front Spar Work
6/1/20 – Bent the HS-702 tabs to 6 degrees per plans. Clamped HS-00001 spar doublers to the HS-702’s as well as the HS-710 and HS-714.
Bending HS-702 tabs to 6 degrees 
Both HS-702’s evening bent
6/2/20 – Matched drilled all inboard holes on front spar assembly to #30 (as shown in view A-A Dwg 3). Removed all clecos and components after marking. Prepared HS-710 to taper ends by drawing 1/4″ radius per plans. I found my rivet gauges (1/2″ wide) worked perfect for this!
6/3/20 – Tapered the ends of HS-710 and HS-714, then bent their outboard ends to 6″ per Dwg 3, view B-B.
I measured starting angle first (was around 1 to 1.5 degrees) then added 6 degrees to that 
